Lifepo4 battery manufacturer Specialized in Energy Storage Battery since 2009.

Precautions for liquid injection in lithium battery production

by:dcfpower     2021-03-19

Preparation of lithium battery pack injection tools: beakers, liquid bottles, glass rods, droppers, plastic tubes, valves and other auxiliary appliances and articles drying: drying in an oven at 60-65°C, drying time ≥ 3h (especially pay attention to remove the water in the dropper tip).

Cloth strips, paper rolls and other difficult-to-dry materials need to be dried in a vacuum at a temperature of 75-80℃ for 8 hours, during which time, the air should be changed every 2 hours;

Check the glove box Moisture content: use a dew point meter to test the moisture in the glove box, the dew point meter shows that the dew point temperature needs to be

≤-30℃; otherwise, you need to replace the nitrogen in the glove box and test again;

Preparation of lithium battery pack electrolyte: pressurize with nitrogen gas into a stainless steel vat of 200Kg pure electrolyte to transfer the electrolyte to a large beaker in the glove box;

Drying method of additives: current The additives used are BG, T, E, VC, and 204. According to their physical properties, they can be divided into two categories: solid and liquid (including those that become liquid after a little heating), solid ones are: BG, liquid ones are: 204, T , E, VC.

Drying solid additives: put the additives in a beaker, stir and mix evenly with a glass rod, cover the mouth of the beaker with 250 mesh filter gauze, tie the mouth of the cup with copper wire, and put it in a vacuum drying box Dry under vacuum (≤-0.08 Mpa) at 65±5oC for 10~12H; after drying, it should be taken out immediately, and the transfer process should not exceed 3 minutes; if you don’t need to take it out immediately, please store it in a dry box under vacuum;

Transfer of liquid additives

(1), directly press out such as 204 and T by high-pressure gas, use a dry container (must be equipped with a lockable lid) after connecting, tighten the lid immediately , Send it into the glove box transition bin within 3 minutes; if there is a pipe directly into the glove box, you can directly enter the glove box through the pipe, and the pipe needs to be kept dry;

(2), Can not be pressed out by high-pressure gas, small packages such as VC can be used in the glove box according to the regulations;

(3) The liquid that needs to be heated, such as E. When it melts, loosen the lid. That is, do not melt open, dry at 65±5°C for 3~4 hours. After melting, add several vials at a time, put them in a glove box and store them in a sealed container for multiple use; E can’t repeat drying more than 3 times.

Related article:

Precautions for the operation of lithium polymer battery cells

Corresponding reasons answer


Shenzhen Chuangneng Ruiyuan Electronics CO.,LTD. helps high-profile clients build strategic relationships that drive company growth, investments, funding and more. There are many make-or-break details involved in the day-to-day manufacturing within our company.
The best way to confront your custom battery pack manufacturers problem is to search for a high quality offered by Shenzhen Chuangneng Ruiyuan Electronics CO.,LTD. at Ruiyuan Electronics. Take a look!
need fuel for energy,while custom battery pack manufacturers do not.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
We will get back to you asap